Battery labelling - what Article 13 requires, and when
· 4 min readCollection symbol since August 2025, general label and capacity in August 2026 subject to a condition, QR code in February 2027, Cd and Pb symbols above certain thresholds. The size rules come with numbers. A paragraph-by-paragraph tour.
Article 13 of the Batteries Regulation gathers everything that must physically appear on a battery. Its paragraphs do not share one date, and one of them depends on an implementing act. Here is what the version consolidated on 13 August 2026 says.
Already mandatory: the separate collection symbol
Since 18 August 2025, every battery carries the separate collection symbol of Annex VI, Part B, the crossed-out wheeled bin. The size rules are precise: at least 3% of the area of the largest side, without exceeding 5 cm by 5 cm; at least 1.5% for cylindrical cells. If the symbol would be smaller than 0.47 cm by 0.47 cm, it is not required on the battery itself, but a symbol of at least 1 cm by 1 cm must appear on the packaging.
The chemical symbols
A battery containing more than 0.002% cadmium or more than 0.004% lead carries the corresponding chemical symbol, Cd or Pb, printed beneath the separate collection symbol, over an area of at least a quarter of it. The thresholds are those of the revised Annex I; a lead-acid battery therefore always carries "Pb".
In August 2026, conditionally: the general label and the capacity
Paragraph 1 requires a general information label, whose content is set in Annex VI, Part A. Paragraph 2 adds, for rechargeable portable, LMT and SLI batteries, a label stating the capacity. Paragraph 3 covers non-rechargeable cells: minimum average duration of use and the words "non-rechargeable".
These three obligations apply from 18 August 2026 or eighteen months after the entry into force of the implementing act harmonising their specifications, whichever is later. The Commission was to adopt that act by 18 August 2025. Until one knows when it entered into force, one does not know the real date of these labels: it is at the earliest 18 August 2026.
In February 2027: the QR code
From 18 February 2027, every battery carries a QR code compliant with Annex VI, Part C. What it must give access to depends on the category:
- LMT, industrial above 2 kWh and electric vehicle batteries: the battery passport of Article 77.
- Other batteries: the information of paragraphs 1 to 5, the EU declaration of conformity, the due diligence report and the waste prevention and management information of Article 74.
- SLI batteries: additionally, the amounts of cobalt, lead, lithium and nickel recovered from waste, calculated under Article 8.
The information reached through the code must be complete, up to date and accurate. It is not a fixed address printed once: it is a link to living content.
Where to put all that
Labels and QR code must be visible, legible and indelible on the battery. Where the size or nature of the battery does not allow it, they go on the packaging and in the accompanying documents. For a cylindrical cell or a button cell that is the general case; for an e-bike pack or an industrial module there is no excuse.
Reuse, repurposing, remanufacturing
A battery whose status changes receives new labels indicating that change, and the QR code must give access to that information, provided for in Annex XIII. The original QR code is not enough if it leads to a passport that knows nothing of the second life.
Three consequences for design
- Reserve the surface now: collection symbol, possible Cd/Pb, general label, capacity, QR code. On a small pack, space runs out fast.
- Tie the QR code to a permanent identifier, not a campaign URL. The code printed in 2027 must still answer when the battery reaches the recycler.
- Follow the labelling implementing act: it sets the real date of the 2026 labels and their layout.