Wh, Ah, V - the unit mistake that moves a battery out of scope
· 4 min readA 48 V, 13 Ah e-bike battery holds 624 Wh. Entered as "0.624", it becomes a watch cell in the eyes of every automated check. Why three figures must agree, and what happens when they do not.
The Batteries Regulation draws several of its boundaries on energy. An industrial battery above 2 kWh carries a passport and a carbon footprint declaration; below that, it does not. A unit mistake on that single figure does not produce one wrong data point among eighty: it moves the battery to the other side of the boundary.
Three figures that are really one
A battery's nominal energy is, by definition, its nominal voltage multiplied by its nominal capacity. 48 V × 13 Ah = 624 Wh. 400 V × 120 Ah = 48,000 Wh, or 48 kWh.
Measured values drift from that product by a few percent, depending on the discharge curve and the test conditions. They never drift by a factor of a thousand. When the declared energy is one thousandth of voltage × capacity, there is no exotic battery behind it: there are kilowatt-hours typed into a watt-hour field, or milliamp-hours typed into an amp-hour field.
What the mistake does
Take a 5 kWh industrial battery. Entered as "5" in the energy field, it is a 5 Wh battery. A compliance check applying the regulation's thresholds concludes, quite logically, that it needs neither a passport nor a carbon declaration. The file passes. The obligation has not moved.
In the other direction, a 624 Wh LMT battery entered as "624,000" becomes a 624 kWh battery. The declared carbon intensity in kg CO₂e per kWh, applied to that energy, yields an absurd total. The public passport shows a figure an attentive buyer spots in a second, and the credibility of the whole file goes with it.
The most common case is the quietest: "0.624 Wh" on the public page of an e-bike battery. Nothing blocks, nothing warns. The page publishes, the QR code scans, and the passport states an energy a thousand times too small.
Why the checks do not see it
A completeness check verifies that a field is filled. A format check verifies that it holds a number. Neither verifies that three numbers are consistent with each other. Yet that is exactly what a physical quantity demands: voltage, capacity and energy are not three pieces of information but one, expressed three times.
The same reasoning applies to other triplets. Mass and energy give an energy density which, for a given chemistry, falls within a known range. A 9.5 kg NMC pack announced at 9,600 Wh would have a density above 1,000 Wh/kg, four times the best commercial product. The figure is wrong before any laboratory test.
What a serious tool must do
- Compute the energy from voltage and capacity, and offer it, rather than leaving an empty field to be filled from memory.
- Refuse an energy incompatible with voltage × capacity at entry time, say why, and offer the most likely correction.
- Run the check again before publication, on the model's data and on the passport's, because they may have been entered separately, by different people, months apart.
- Never repair silently. An automatic correction that multiplies by a thousand without saying so moves the error instead of removing it.
What this asks of your suppliers
Most datasheets give capacity in Ah and energy in Wh for packs, but mAh and Wh for cells, and sometimes kWh for systems. An import sheet mixing rows from those three origins without a unit column will produce the mistake every time. Putting the unit in the column header, and checking it on import, costs less than withdrawing a published passport.